![]() Prepare a bias-cut fabric stripe that is 2,4 cm (about 1 inch) wide and slide it through the opening as shown in the images below. You can mark yours in centimeters or inches. Next to the smaller opening, write down the width of the bias tape, when sewn and folded. Next to the larger opening, write the width of fabric that needs to be cut for the bias tape maker. With just the push of a button, it feeds your. The bias tape maker should look like this ( see the image below): 5. If youve never used one, Simplicity Bias Tape Maker is a handy machine that makes bias bindings automatically. You can always make this opening bigger if necessary. It is better to cut inside the outlined lines and make it a bit smaller. Make sure that there are visible outlines where to cut ( see the image below).īe careful with the smaller opening. You may need to flip the cardboard and cut the openings from the other side too ( see the image below). Now that the openings are pre-drawn, take your cutter (or another cutting tool – NOT scissors) and cut out both openings ( see the image below). 3 Easy Steps: Cut the fabric strips to roughly 3-7/8. 2,5 cm (1 inch) for the larger opening where the fabric stripe goes in, then 1,2 cm (1/2 inch) where the fabric stripe goes out. This tool makes the task of making bias binding or facing tapes easy with a great looking result. Mark the height of the openings where the fabric will go in and out about 2,5 cm (1 inch) from the cardboard edge ( see the image below).ĭraw the opening widths. Outline the openings for the fabric stripeĭraw the central line of the rectangle along its longer side (see the image below). Take the cardboard and cut out a rectangle 9 by 7 cm (3 1/2 inch by 2 3/4 inch). ![]() I do not recommend making bias tapes makers for thin bias tapes (less than 0,5 cm – 1/4 inch when folded). Also the bias tape maker might be a little inaccurate as a result of hand drawing and cutting. Keep in mind that, depending on the fabric, the resulting width might be slightly different. In this tutorial, I’m going to demonstrate how to make a bias tape maker that creates a bias tape about 1,2 cm (1/2 inch) wide when unfolded and about 0,6 cm wide (1/4 inch) wide when folded and sewn. Stripe width = 4 ⨯ final tape width – 1/16 inch Bias Tape Maker (1 - 40 of 257 results) Price () Shipping All Sellers Clover Bias Tape Maker- 2' Width (2.9k) 14.50 5pcs Fabric Bias Tape Maker Set Binding Tool Quilting Sewing - 5 sizes (1.8k) 10. ![]() Stripe width = 4 ⨯ final tape width – 2mm ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |